The 10 Rules of Flooring And How Learn More

4 Stages To Do Hardwood Floor Refinishing Correctly

When it comes to hardwood floor refinishing, homeowners should know that planning and patience and skill won’t be enough as they ought to have specialized equipment as well. Out of all the projects for home improvement that any homeowners can take, this is something that needs research, knowledge and time. You’ll be going through a series of steps or stages that include preparing, evaluating, sanding as well as sealing your hardwood floors.

Even a slight touch of mistake is more than enough to cause problems that may last for a long time in any of the said stages or steps. It is possible that you can perform the refinishing of the hardwood flooring alone but it is suggested that you also get some help. It takes 1 to 3 weeks to carry out refinishing for such type of flooring.

Step 1. Checking the hardwood floor – it is important to figure out first if the hardwood floor planks are going to be a laborious process. You have to assess if the floor suffered from water, pet urine or spills. In order to see if the boards are so thin to be sanded, you may pull up one threshold of the door. Additionally, you need to figure out if the last sealant was varnish, wax or polyurethane. Of course, to know if the hardwood flooring have deep gouges or dramatic wear patters, you’ve got to give it a thorough examination.
Learning The “Secrets” of Flooring

Step 2. Preparing the flooring – you must prepare the flooring first before you do hardwood floor refinishing. If most of the hardwood planks don’t have scratches or holes, are at least 3/4 inches thick and have same amount of sealant, then you’re all set to start with the preparation.
Looking On The Bright Side of Floors

First thing that you’ve got to do is clean the whole floor area. You need to file any holes from nails, staples or scrapes. Moreover, you will have to pull up the baseboards and the thresholds too. You need to do all the floors to keep it consistent even if one of the floors not looks good.

Step 3. Sanding – this is probably the most daunting and the most demanding step that you would ever do. You need to rent a drum sander equipment, this is loud to use and you’ve got to roll it to the entire hardwood flooring 3x to be able to peel off the top layer of the finish.

Step 4. Staining and sealing – you need to be sure that every single bit of sawdust is gone so it doesn’t contaminate the sealing and staining applications before starting on this step. Once you’re done staining the floor, you now have to seal it with thin layer of sealant to be sure that the stain is dried completely prior to application.